If the problem persists, contact CAREL service; otherwise the connection that was removed was short-circuiting the power supply.
![]() Carel Winload 32 Free Contact CanPassive: 4 (inputs B4, B5, B9, B10) -CAREL NTC (-50T90C; RT 10k 1 at 25C) or HT NTC (0T150C) -PT1000 (-100T200C; RT 1k at 0C) or digital input from voltage-free contact Can be selected via software.
There is double insulation between the groups (cells in the table) and consequently these may have Insulation distance different voltages. Input resistance: 100 Can be selected via software Universal: 2 (inputs B3, B4) -CAREL NTC (-50T90C. For the temperature probes, use the 4 to 20 mA or NTC configuration, as the 01 Vdc signal is limited to the restricted 0-1 V range and therefore is not always compatible with the standard 10 mVC signal of the CAREL probes (for temperatures below 0C and above 100C, a probe alarm may be generated). The inputs must be configured for 0 to 20 mA or 4 to 20 mA signals by the application program resident in flash memory. The inputs must be configured for 05V ratiometric signals by the application program resident in the memory. The inputs must be configured as voltage-free digital inputs by the application program resident in flash memory. These inputs are all optically-isolated from the other terminals and can operate at 24 Vac, 24 Vdc and some at 230 Vac. To make the connection, simply plug the telephone connector into the RJ12 jack on the rear of the terminal, and in connector. To make the connection, simply plug one of the connectors into the RS485 jack on the terminal and the other to connector. For further information on the parameters and on the variables that can be exchanged, see to the user manual. Today in fact, with the expansion of BMS, the issue of communication between controllers made by different companies is increasingly important. CAREL has consequently developed compatibility with all the protocols that are emerging as the standards in HVACR and intelligent management systems, such as Modbus. ![]() For the technical specifications and the meanings of the connections (pins), as well as details on the procedure for fitting the board, follow the instructions shown on the instruction sheet provided in the packaging (code 050003265). Ta Ta Ta Tab. 6.a b. Cases in which the pCO enters LOW LEVEL. Carel Winload 32 .Exe Program AndTo do this, CAREL provides the WinLoad32.exe program and an RS485 serial converter for the pCO. Carel Winload 32 Driver Needs ToThe special driver needs to be installed on the PC, again supplied by CAREL. Otherwise, there must be another possible procedure for selecting the protocol (e.g. Not all the CAREL pCO controllers have an ID number; if this is not present, the following screen informs the user of this situation. NAND FLASH FILES:::: this row is only displayed on the pCO3 boards that have additional NAND flash memory. If this is still near zero, turn the controller off and wait a few minutes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |